R3 DIN Printed Circuit Board or Kit

MIDIfication
1

I need one additional DIN for my midification of an old Conn.  Either the board, the kit (Smash TV), assembled, or the files to make the board or a schematic.

Adding a third keyboard to my setup and no room left on my 7 DIN boards.

Thanks

Jay

2

http://www.ucapps.de/ has the info you need.

Best,
Andy

3

I’ve got a bunch of prototypes of this combined DIN/DOUT module board that I made…  Haven’t tested it thoroughly yet, but it should work fine.  If you want to try one of these boards I could mail you one.  $5 +postage?

Alternately, ucapps has board files and schematics.

< base_url >/topic/20783-pcb-combined-dindout-x4-modules-on-one-pcb-comments/?do=embed

 

4

Hello

 

13 hours ago, Jay Beckham said:

Adding a third keyboard to my setup and no room left on my 7 DIN boards.

Look like MB_NG and MB_KB only support 2 keyboard, If you need a third I guess you need another core too

Best

Zam

5

Each of my core8 support four din boards.  Each DIN supports 32 inputs.  So I have purchased one more DIN for a total of eight.  8 * 32 = 256.  So three manuals is 3 x 61 = 183. which is 6 of the DIN boards.   One DIN for my pedals and the other one for toe pistons and combinations.

| Core Boards | First Pin | Last Pin | Use | DINS |
| CORE8 0 | 1 | 61 | Manual 1 | 1, 2 |
| Beckham 0 | 62 | 64 | NC |   |
|   | 65 | 125 | Manual 2 | 3, 4 |
|   | 126 | 128 | NC |   |
| CORE8 1 | 1 | 32 | Pedals | 5 |
| Beckham 1 | 33 | 45 | Combinations | 6 |
|   | 46 | 64 | Pistons |   |
|   | 65 | 125 | Manual 3 | 7,8 |
|   | 126 | 128 | NC | NC |

Already have two combination boards of six each to mount on the front of my keyboards, a DIN in the mail, and my third manual arrives tomorrow.

Jay