jog shuttle question

MIDIbox HUIs
1

Hello

    ive finally got round to finishing the new mixer layout for my all in one midibox (see pics)

  im stuck as i dont know how to connect the jog shuttles

  heres the data sheethttp://www3.alps.com/WebObjects/catalog.woa/E/PDF/Switch/Encoder/SRGP/SRGP.PDF

  ive been reading this and wild weasels build log for his dennon controller, but i just cant make sense of it.

  There are eight connectors on each jog shuttle

          1          2          3        c1          4          j2          c2              j1

  on normal buttons (din) theres one ground pin and one send pin ,so if these jog shuttle act like four buttons in mios which pins are the ground and which pins are the send?

  any help would be appreciated as its become frustrating so near yet so far

regards kris

P1010028.JPG
P1010028.JPG640×480 115 KB

P1010050.JPG
P1010050.JPG640×480 133 KB

P1010028.JPG
P1010028.JPG640×480 115 KB

P1010050.JPG
P1010050.JPG640×480 133 KB

2

http://www.reloopdj.com/media/products/221546_RELOOP_SM.pdf

page 18 : part list JOG201, JOG202 - SRGPHJ,

page25: the schem how to connect the jog shuttles to the 74HCT165 and 10K resistors.

May be it helps.

Regards, Janis

3

c1 and c2 (common pin?) are the ground pins.

all the other pins go to one input pin on the DIN module.

J1 and J2 are the pins of the encoder (rotary thing in the middle)

the other 4 pins belong to the shuttle ring.

that’s it. You need to do some programming though to make them work, f.e. with the C interface.

regards,

michael

4

  thanks very much for the quick reply thats exactly the information i needed

  ill worry about the programming when ive built it

  regards kris