Encoder no5 seems to send the display into meltdown and ends with the display reading ‘no songs available as long as the session hasn’t been created Please EXIT and create a new session!’
Will it have something to do with the datawheel encoder and leds currently not being soldered on
Are you using the correct hardware configuration file for a Wilba panel?
Yes old chap
just went over the board searching for wrong deeds
I’d missed a few soldering points on two of the RAs and one resistor
Have just soldered and tested and all is working. This has made my week
Nice! Missing pull-up resistors (resistor networks) will often cause havoc with the switching behaviour :).