Wilba controls mixed up

MIDIbox SEQ
1

EDIT - found my error…  my computer’s “Q” key is flakey and my config file was named ‘MBSE_HW.V4’   :rolleyes:

Things are working good now  :smile:

 

My SEQ4 is almost alive :slight_smile:

 

I hooked up the (Wilba) control panel and the controls seem to be mixed:

Encoder 1 –> STEP mode

Encoder 3 –> turns SCRUB on/off

Encoder 4 –> moves cursor across screen

Encoders 13/14/15/16 –> change notes in positions 4, 3, 2 & 1 respectively

Data Wheel –> changes note in position 6

 

The buttons do not do the expected things; many seem to do nothing.

 

I do *not* have the LEDs in place yet (does that matter?)

 

Do I maybe have my connector cable wired backwards?

 

I do not get an SD card read error.

 

Any suggestions?  thanks,

Drew

2

i ran into a somewhat similar issues a few weeks back w/ my new seq4. i would try another SD card, formatted freshly to fat/fat32 w/ the config file. mine was not showing an error on the mb during load but the sd card itself was corrupted when checking via a computer.