Hey everyone!
I’ve never made a PCB before, but need to create some for my Sparkfun Buttons:
http://www.sparkfun.com/commerce/product_info.php?products_id=7836
For use with the DIN Module for a Midibox64, is the attached image going to work? It seems like it would, but am I missing something? Like resistors or it’s just completly wrong etc…
Thanks for any help.
Christian
That’s going to work.
Woop! Thanks for letting me know!
It’s a good job because I just went and photoshopped up a circuit board for it (based off Exported Eagle images, so should be to size etc). See attached.
For all you DIY Etches, is this going to be possible, or are the tracks too fine? Theres room to make them bigger really, so I could do that. IF DIY is possible, I was going to head down the route of Laser Printer, would this be ok, if not tedius? Or should I really be looking at exposing the boards?
Thanks for all your help guys/girls! I’m starting to see the end of the tunnel.
Christian
