Hello, i bought for my SEQV4 a SD Card adapter kit : MOUSER PART
But i have a problem :
i follow these 2 page :
But on this adapter i don’t see VSS and VCC; so i don’t know how to connect it.
Do you know how it work ? i search but didn’t find something about the shema of the adapter.
Another question :
Do i have to sold the SMD part ? (see on pictures) ?
All the picture here : <___base_url___>/gallery/album/150-lamouette-seqv4/?do=embed
Thx !!
VSS=GND
VCC=3.3V
The small SMD parts should normally not be necessary.
Bye,
Peter
ok, thx for your answer ! (you are so quick ^^)
I read on the SDCARD PDF that :
PIC based MBHP_CORE (5.0V IO) requires additional resistors (voltage dividers)
and a 3.3V Voltage Regulator
cause i will use 5v screens, maybe i have to had something ?
ok, thx for your answer ! (you are so quick ^^)
I read on the SDCARD PDF that :
PIC based MBHP_CORE (5.0V IO) requires additional resistors (voltage dividers)
and a 3.3V Voltage Regulator
cause i will use 5v screens, maybe i have to had something ?
If you are running a core32 or LPC, those will already have 3.3V via jumper selectrion (and those supply +5 to screens). Only the PIC base core that runs at 5V needs the 3.3 vReg
Ok, it will work so. Thx all !