Hi…
Just saw Mega MIDIbox (jaw on floor again) diagram and am wondering if i could put all modules on one pcb - the enclosure unit would be pretty large so i guess the wires from the AINs to some of the pots could be quite a length - is there a limit to the length of wire…
Prolly, another basic EE q - but, again, i’m new 
Peace…
Dan
…also…
what solder/flux is recommended? can i use flux-cored solder wire instead of doin it sep…? do i have to use a diff solder for SM components…?
Thanks…!
apologies…last post not really a ‘design concept’…more ovva ‘novice-newbie’ one ;
cheers…
Jast saw: http://www.midibox.org/midibox64_walkthrough/pot_wiring.jpg
got that sorted then i guess, and the i’ve goolged the solder/flux issue…panic over
Best experiences have been made with seperated AIN modules which are as close to the pots as possible (see also the pictures at the bottom of http://www.ucapps.de/mbhp_ain.html). All other modules can be combined to one PCB without any risk of unstable signals.
You could also try to create a AIN board which allows you to mount the pots - this saves effort, but requires some experiences in layouting a PCB.
Best Regards, Thorsten.
P.S.: I hope that somebody else can provide some good links to soldering guides…
Some soldering links:
http://www.doubleogauge.com/journal/soldering.pdf
http://www.elexp.com/t_solder.htm
http://www.seattlerobotics.org/encoder/200006/oven_art.htm
http://et.nmsu.edu/~etti/fall97/electronics/solder.html
http://www.users.globalnet.co.uk/~bunce/solder.htm
1 or 2 may of already been mentioned, but i’ve learnt alot already frm the above links…
HTH…
Dan
Was thinking about a ain board like the one thorsten mentioned a while ago… Even got to the point of laying one out…
The concept i came up with allowed all boards to be ‘daisy chained’ with a single idc ribben cable Might finish this off sometime soon, and post a link to the pcb files???!!
Great!!
