Need adice trouble shooting sammich - buttons/knobs **FIXED**

Testing/Troubleshooting
1

Ok So, I am at the stage of the build, got my 12v regulated power supply - tested voltage - all good. Installed IC, load mios - installed banksticks and sids - sound good.

I am not getting any functions from buttons and knob. LCD works fine.

Now, the mistake I did make was put the 6 pin Common bus resistors in backwards - I took them out adn re installed the right way (way to go), check voltage, all is good - still no response from buttons and knob.

Can you advise please. thanks.

Man just when things were going so smooth and bhaaaa, had to make some sort of mistake.

2

i crack myself up, found my problem IC in wrong slot. Thanks for your help. I hope any one reading this by passes this mistake

3

I just loaded the patches - I just wanted to give a shout out to TK and who ever else helped make those patches - super sick. this machine is raw. And wilba sick sickness on the sammich - very fun build. I look forward to diving into this machine and understanding its features better. you guys rock

4

I blame nILS :poke:

5

I accept :frantics:

6

thanks to you nILS