Hello,
Is there somewhere on the forum an explication about how is mounted the CS pcb with the Front Panel and with the same case TK uses?
Also, what is the value in mm of the distance between the PCB and the front panel?
Where did you get these “distance” bolt?
Best regards,
PK
Hi,
I believe you will find the answers to your questions in the wikipage here: http://www.midibox.org/dokuwiki/doku.php?id=wilba_mb_seq_construction_guide
best regards
offe
Hi,
you can also check out the following thread: http://www.sequencer.de/synthesizer/viewtopic.php?f=13&t=70858
The description is in German, but there are a lot of pictures. Please note that I have modified the front panel with some profiles at the ends of the front panel. This was necessary to prevent the front panel to move when the sequencer is turned up side doiwn 
I will finish this thread soon, as I have now received my rear panel. Once my sequencer is complete, I will update the WIKI with my tutorial.
Cheers
orange