Hi all,
I’d like to know if the LEDs should be bright at start-up ?
Best,
Pierre
it all depends of your apps.
paste the code
well taken from the title its the default mb64 code, adn whats the default status of the leds without code change.
adn?
Yes, when I turn my midibox on, all the leds are on (bright). I guess it’s not the default setting for a midibox 64. Perhaps I got a hardware problem. I’d like somebody to tell me.
could you paste your code here…?
Actually I’m using a default ready to upload .hex file.
What file would you like to see ?
Protofuse: he uses the MIDIbox64 firmware…
No, all LEDs should be off.
Are the buttons working?
If no: there seems to be a general problem with the SRIO chain, debugging help here: http://www.midibox.org/dokuwiki/doku.php?id=din_module
If yes: there seems to be a connection problem between CORE:J8 and DOUTX4:J1 - the srio_interconnection test (as described on the DIN module page) helps to debug this as well.
Best Regards, Thorsten.
TK answered 
Buttons works fine : after pressing one, the LED is off unless I press the corresponding button.
Thank U, I know what to check now.
Pierre
Ok, thats a different scenario: the core is able to control all LEDs, correct?
In this case the hardware is ok, and it’s very likely, that you stored “all-LEDs-on” in the default snapshot.
Turn off all LEDs, and press the snapshot button again (for ca. 3 seconds until the store function is triggered)
Best Regards, Thorsten.
You’re right, shame on me.
Thx
Pierre