Hi,
I’m building a Core Modul on the Design on T. Close v3.
The Midi Out has strange(?) 10V. Seems incorrect to me, but I’m not in Midi-Specification. The Voltage supply of the Microcontroller and smaller Chip seems korrect (5V at all points in the introduction).
Any Idea?
Thx,
Dennis
Update:
Seems to be my fault: I just was on AC not DC. With DC I get 5V+ on both outer Pins to the Groud Pin (middle). This should be correct, or?
Additional Info:
I’m just before loading up the syx file via midi into my bootloader and don’t want to blow up my [expensive] soundcard. I even ordered a cheap Midi IO Cable to go for sure now. I can use it anyway for Laptop+Synths.