hi,
how to change the sr pinout for the accent 1 and 2 ?
i need to attribute the accent output to sr 11 pin 0-1
but i see nothing into the setup_808_default.asm about the accent2 …
best regards
Hi,
there is’nt a second accent…
Where did you find informations about “accent 2”, maybe you mean something else?
Best Regards, Thorsten.
.
Where did you find informations about “accent 2”
on MB-808 Revision 3 Shift Register Pins ==> http://www.eight-oh-eight.org/Rev3/shiftregistersrev3.html
Ok… this one is new to me, at least it isn’t officially supported.
However, you can use any track to generate accent pulses.
E.g. you could use Track 15 (by default assigned to “Ext3”) for this purpose, just specify the right SR and pin number.
Best Regards, Thorsten.
Ok… this one is new to me, at least it isn’t officially supported.
However, you can use any track to generate accent pulses.
E.g. you could use Track 15 (by default assigned to “Ext3”) for this purpose, just specify the right SR and pin number.
Best Regards, Thorsten.
ok thanks
but i’m confused with the accent part on my 808 clone
maybe you can help me
If I have understood correctly the 808 accent shematics i need 2 triggers for triggering the accent voltage
but when i connect 2 triggers i got no sound
with only one trigger (accent1 in)i have sound but not accent and the accent pot give a volume control …
do you have an idea of the problem.?
ok i find the way
mb accent trigger output to ==> tr-808 accent1 in
tr-808 accent2 in ==> connected to the gnd !
1 Like