In the Eagle Light file (mbhp_burner_v1.brd) there are some pads not connected to any wire, I observed the gif (mbhp_burner_v1.gif) and there are a groud area that is no there in the Eagle Light file (the program is showing me all the layers)… what’s happen? ??? ??? ???.
  Another question: I will use the Eagle Light file to make my PCBs: How I reduce the diameter of the pads and vias holes? ??? ??? ???. Thanks.
Hi,
the ground area is not visible by default - it will be visible once you type the “rats” (“ratsnest”) command.
Changing diameters: type the “change” command
Best Regards, Thorsten.
it will be visible once you type the “rats” (“ratsnest”) command.
Also, I think it will disappear again for some reason when you close or quit.
Thanks to you Thorsten and Jidis. ;D ;D ;D ;D
Thanks to you Thorsten and Jidis. ;D ;D ;D ;D
This is an old thread, but I’m having this same issue after I type in the ratsnest command. Specifically, on the v1Plus board, one pad of R8 doesn’t connect to anything. The other end is connected to pin 8 of IC3.
Is there a schematic of this version of the board somewhere? It looks like the part numbers are all different compared to the first version. Finally, is the Eagle .sch file available? I searched for all this info, sorry if I missed it.
Thanks!
Dave
Could you please contact Mike and inform him about this error? (I also see, that one pin of R8 is open… compare it with the original layout to see how it should be connected)
Best Regards, Thorsten.
Could you please contact Mike and inform him about this error?
Assuming it’s the ele*****ix00 @ aol.com address, I just sent him a message. Thanks Thorsten.
Dave
Edit: for what it’s worth, this appears to be the needed correction. It shows up as an unrouted connection at C6.
um, what board is that? Those values do not correspond the the mhbp_burner_v1.brd file i have (its R10 and C8 on mine, and they do connect)
It’s the *_plus.brd file - Mike will send me a fixed version in the next days
Best Regards, Thorsten.
