Hi. I meant to do this a couple days ago but Here it is. I should probably put this in the wiki but I am too lazy to figger’ it out right now (hard days work and everything)
Earlier this week I was looking for which knob went to which pad because I’m building my own CS. I built a rough copy and traced the knobs back to the DIN pads on the PCB. I know this will be helpful to someone at some point.
I just put the generic functions. Clearly each engine has it’s own specifications and they are all a little different, but you’ll be able to get the gist of it for planning purposes from this.
If somebody sees any mistakes Pipe Up!
JD1:
D6/D7 = Menu
D4/D5 = LFO Depth
D2/D3 = Envelope Release
D0/D1 = LFO Rate
JD2:
D6/D7 = Envelope Sustain
D4/D5 = Oscillator Release
D3/D2 = Envelope Decay
D0/D1 = Oscillator Sustain
JD3:
D6/D7 = Envelope Attack
D4/D5 = Oscillator Decay
D2/D3 = Envelope Depth
D0/D1 = Oscillator Attack
JD4:
D7/D6 = Filter Resonance
D5/D4 = Oscillator Decay
D2/D3 = Filter Cutoff
D0/D1 = ???
Wiki’d!!!