Help seems to be needed

Dimitris_FX_freak · March 14, 2003, 1:19am

Ok I am not that familiar with assembly, neither with digital electronics ferther than Ohms law so I think I am stack on some point.

Building a LC emulation with MIOS.

As I see in the tables.inc of the LC application I only see registers

MIOS_MPROC_EVENT_TABLE

Â Â Â ;; entry 0x00-0x0f

Â Â Â Â Â Â Â Â Â Â Â Â Â Â Â ;; Rec/Ready Buttons

Â Â Â MT_ENTRY Â Â Â 0x90, 0x00 Â Â Â ; Rec/Rdy Track1

The addresses 0x00-0x0f reffer to first DINX module or the first 16 pins of the first DINX. Same goes for DOUTS etc.

It might sound silly but I am really confussed Â ??? ??? ???

T.K · March 15, 2003, 4:19pm

Hi Dimitris,

first question before I write 1k of infos which you already know: did you download the Logic Control Manual from the Emagic site? Because this manual comes with a description of all “button IDs”

Best Regards, Thorsten.