Hi, excuseme my english is very bad, (im Spanish)
I have mounted CORE and a plate AIN, I have programmed the PIC with the Firmware of the 64 MIDIBOX V2.3 with the JDM. I ignite but it does not do anything, not send any midi message. The voltages are correct and the PIC does not give programming problems. I do not even have a LCD but I believe that nothing goes. Some aid?
???
Regards.
Hi,
Program the pic with MIOS “bootstrap loader” (explanation: http://www.ucapps.de/mios_bootstrap.html). Then you will have to upload the MIOS and then the firmware using midi.
Bye, Moebius
I have loaded bootstrap and receipt answer 01 00 F0 00 7E 40 00 F7. I already execute sysexbox but it does not load firmware.
Thank
Is it really “01 00 F0 00 7E 40 00 F7”?
Then it could be a general problem, because the request string is “F0 00 00 7E 40 00 01 F7”
Which parts of the MIDI troubleshooting guide have you already tried out?
Which tests are failing?
-> http://www.ucapps.de/howto_debug_midi.html
Best Regards, Thorsten.
double posting…
Thank TK
Another problem. I have loaded the program finally in the PIC. Now appears a new problem of nascent.
Once I ignite CORE begins to send to random messages midi.
I have connected single one pot and I have taken to ground the rest of pins of J5. Now when single igniting I see the message of starting of the MIDIBOX, but when I touch a pot begin to go off the messages and they do not stop.
At the moment the configuration is the following one:
CORE
AIN (not connected)
Whom I need.
Excuseme but when not speaking ingles costs much to find answers to me much in the Forum. Thanks for its interest.
???
I have leido all the forum and I have seen wur my problem happens to him to much people.
The problem is that when I am called on pot beginning to receive random messages midi.
I have modified the MIOS to prove with single pot. I have put pins of J5 that nonuse to ground. and it follows equal.
It is necessary to ground other pin?
Excuseme my english.
Thank
My CORE PCB is the V2 of the web of SmashTV.
is compatible this PCB with MIOS 1.7?
they can be my problems for that reason?
Please help me.
Hi midiman
Triple check the wirings, I connected in a wrong manner the pots and I experienced the same problem, if the wirings are ok you should check the infos on ucapps which are very precious, I know it is a little hard to understand them if your english is not good, but if it weren’t for the troubleshooting guides I would be buying expensive midi controllers now 
Or,
maybe you should buy a Midibox? There might be some, on the eBaY?!
bye, Moebius
Thank SounDuke for you help. I continue proving.
Moebius, I have enough experience in assemblies, previously make the EDRUM without any problem. But I think that my problem is my inglis, I read all post and every day I learn something, yesterday to discover that i must have connected the board DINX and I have not even connected it, I believe that that is the problem. In any case thanks for the shown interest.
Ploblem resolve.
The problem already works the MIDIBOX was of the connections with the AINX.
Thanks for help me.
Closed Post !!!
:-X