Gettin the buttons right

MIOS programming (Assembler)
1

Ok guys

The encoder functions are going well but now I want to add the buttons.

So instead of encoders I stuff a button to pull hi and lo

on the next pin.

Problem is that the next two pins ( which I have buttons connected to ) both show the same pin number.

They seem to be using the same as an encoder does, you know like two pins for input per encoder.

How do I change this to get the button to only function on a single pin.

Cheers

Ian

2

Hi Ian,

check your encoder table in mios_tables.inc, all unused encoder entries have to be replaced by ENC_EOT.

Btw.: if it’s too complicated to add a button handler, just wait for the MIDIbox16E port (which will also allow to use more than 16 encoders), release: possibly after my holidays.

Best Regards, Thorsten.