This has been bugging me for a long time,
On my DOUT boards from Smash, the pin assignment seems weird.
When I activate Pin 0 { MIOS_DOUT_PinSet(0, 1); }
J3 D6 is triggered, at pin 1 J3 D7 is triggered.
going upward is
D6, D7, D4, D5, D2, D3, D0, D1.
Then it goes to SR 1 and repeats the order
Is this correct, or is there something weird going on?
I would expect D7, D6, D5, D4, D3, D2, D1, D0 (see also this table)
How is MIOS_DOUT_PinSet() triggered - via buttons, MIDI, MIOS Studio, …?
Best Regards, Thorsten.
Thanks TK.
All of the above 
I used dout buttons app for confirmation.
Been using a bank of 8 leds for testing (I’ve checked the connections a hundred times).
Tried diffferent DOUT boards, different SR’s. Always the same.
It’s been about 18 months since I tested with a multimeter though. I’ll check it when I’ve got a few minutes to breathe again
I’ve always just dealt with it, till now when I fkd up a custom pcb for relays. fixed by swapping pairs on the ribbon cable around, but it hit me that it didn’t make much sense (nothing did 18 months ago :D).