CORE32 Firmware Upload

MIDIbox SEQ
1

Hi,

Today I tried to load the SEQV4 firmware into the CORE32 but there was no response. The USB connection was established and the MIOS Studio stated that the core is ready for the upload. I started the upload of the “project.hex” but there was no response from the core. MIOS Studio dumped a warning into the message log:

Do I need to set a specific jumper in order to upload the firmware. I read the manual a couple of times but I couldn’t really find an advice.

Cheers

orange

Upload_Failure_01.jpg
Upload_Failure_01.jpg826×722 114 KB

2

I was able to load the SEQV4 firmware to the Core32 after the selection of the appropriate device “00” [not “01” :-)]

But thanks for looking indeed :slight_smile:

Cheers

orange

Upload_Start.jpg
Upload_Start.jpg826×721 126 KB

Upload_Completed.jpg
Upload_Completed.jpg822×718 127 KB

3

First tests with some components are fine, but where is my control surface !?!? :slight_smile:

Cheers

orange

Check_Bootloader.jpg
Check_Bootloader.jpg1024×813 120 KB

Check_Components_01.jpg
Check_Components_01.jpg1024×727 103 KB

4

Good to hear you got it working. And also nice to see my Core32 is put to use :wink:

5

You´ve definitely already got that famous MBSEQ four-four time C-3 beat going :slight_smile:

6

Where’d you get the SD card PCB?