AOUT_NG + SEQV4

Testing/Troubleshooting
1

Allo ! :rofl:

 

I have a problem with my AOUT_NG, impossible to have voltage on the CV outs, i have read alot, checked everything but can’t find the problem :no:

 

I tested with single ground, double ground, but impossible to have something else than 0V

 

My SEV4 is powered from an external power supply, everything else work but the AOUT_NG

 

I have 12V at IC3, and IC4, led is up, the mid IC don’t fell too hot, i have also modified the Firmware, and set it to 3.

 

What i can check to be sure i donmt have others problem ?

 

Thanks for your help. Bye !

 

 

post-9818-0-67352400-1396488581.jpg
post-9818-0-67352400-1396488581.jpg1200×900 130 KB

2

Sorry if this is an obvious question, but do you have +/-12V? You only mention +12V (and not -12V) and I can only make out 2 yellow wires going into J3. 

 

J3: Analog power in (+12V/GND/-12V)

http://www.midibox.org/dokuwiki/aout_ng

3

Yes, i have the +12/-12/0v connected.to J3.

4

Did you correctly change the sequencer output to AOUT1-8? The default will be USB, MIDI, IIC etc.

 

Failing that you could try the TEST AOUT PIN program from the Core, it should be somewhere on ucapps.de

 

 

Bonne chance,

Andy

5

Hello, Yep, i changed it to AOUT Channel 1,

 

I will try to find this.

 

Thanks. Bye

6

How did you connect it? 1:1 or 
CORE SO - AOUT_NG pin4
CORE SC - AOUT_NG pin5

CORE RC1 - AOUT_NG pin3?

7

Hum, looks like a connected it 1:1, i will check this tonight ! More news tommorow !

8

Ok, it won’t work with a 1:1 connection

 

Best Regards, Thorsten.

9

Shame on me :rolleyes: ! Here is a SEQV4 totally working, with an axternal PSU, AOUT_NG, QUAD ICC !

I’m working on a tilted metal case, to fit everything inside ! I’M so happy guyz ! I already played a lot with it, it’s just so good, A really good job, and i think lot of work for you ! Cheers TK, and Thanks for all the midibox community, which is just for me the best community in DIY (Shared with MI :smile: )

 

Here is an happy guy ! :purple: