AINSER configuration (Aftertouch)

MIDIbox NG
1

Hi,

 i get note values instead of numbers when i press aftertouch.

[397400.935] d0 64 Chn# 1 Aftertouch E-6 [397400.937] d0 63 Chn# 1 Aftertouch D#6 [397400.938] d0 61 Chn# 1 Aftertouch C#6 [397400.939] d0 60 Chn# 1 Aftertouch C-6 [397400.940] d0 5e Chn# 1 Aftertouch A#5 [397400.942] d0 5c Chn# 1 Aftertouch G#5 [397400.943] d0 59 Chn# 1 Aftertouch F-5 [397400.944] d0 42 Chn# 1 Aftertouch F#3 [397400.945] d0 16 Chn# 1 Aftertouch a#1 [397400.946] d0 14 Chn# 1 Aftertouch g#1 [397400.947] d0 00 Chn# 1 Aftertouch c-2

Here my NGC config

EVENT\_AINSER id=6 type=Aftertouch chn= 1 range=0:127 offset=0 ports=1000100000001000 lcd\_pos=1:1:1 label="^std\_aser"

 

Shouldn’t it look like this? (note the numbers after Aftertouch)

[397400.943] d0 59 Chn# 1 Aftertouch 21 [397400.944] d0 42 Chn# 1 Aftertouch 34 [397400.945] d0 16 Chn# 1 Aftertouch 57 [397400.946] d0 14 Chn# 1 Aftertouch 29 [397400.947] d0 00 Chn# 1 Aftertouch 16

 

Thanks in advance!

 

2

Same here. But it seems to be correct. I’ve used it a lot already. 

3

Thanks for looking into this.

So far i’ve only tested with MIOS studio and was a little irritated by this. I’m looking forward to testing it in a real world setup.

4

Yes, I think it’s only a display problem in MIOS Studio, I should change this to a decimal value.

Best Regards, Thorsten.

5

Thanks Thorsten!

6

…

7

…

8

new thread:

< base_url >/topic/21191-note-off-events-missing/?do=embed